Installation Instructions
1/2" and 7/8"
Transmission Line Kits
for Motorola Low-loss Foam Cables
with Mini-UHF Jumper Cable

Bulletin 23708X1

Description
The Motorola transmission line kits covered by these instructions contain all the transmission line components required to connect your Motorola Base Station to the antenna. Short jumper cables are located (one with 1/2"
main line and two with 7/8" main line) to provide greater termination flexibility and easier connection. Connectors have been factory-attached to the cables to simplify field installation. Line kits vary according to cable size and type of connector termination as indicated in Table 1 and Figure 1.


Table 1. Line Kit and Replacement Part Ordering Information
Line Kit no. - order from
Motorola Communications Systems
Products (Product code 207)
Replacement Parts - order from
Motorola National Parts
Products (Product code 207)
TDN7767A TDN7768A TDN7769A TDN7770A TDN7771A TDN7772A Part No. Description
Jumpers (foam)
1-80306A601/2-inch, 6-foot, UHF male both ends
1-80306A611/2-inch, 6-foot, N male/UHF male
1-80306A631/2-inch, 6-foot, N female/UHF male
00000000001/4-inch, 8-foot, UHF male/mini-UHF male
Main Lines (foam)
1-80306A641/2-inch, spcl. length, UHF male/UHF female
1-80306A651/2-inch, spcl. length, N male/UHF female
1-80306A661/2-inch, spcl. length, N female/UHF female
1-80306A697/8-inch, spcl. length, UHF female both ends
Items Common to All Kits
10M132155
1A84608A
11TA34678
11TA834679
3S69990
2S2878
4S7693
42A82268C01
3S400015
2S2888
7B822202C01
64B82201C01
20 no. 14 tie wires, 18" long, for 60-foot cable run
Hardware kit, consists of:
(1) Silicone grease, no. 4 tube
(1) Roll of vinyl tape
(3) 1-4-20 x 3/4 inch bolts
(3) 1-4-20 hex nuts
(3) 1/4 lock washers
(2) Rawl plugs<
(2) No. 14 self-tapping screws
(1) Large brass nut
(1) Mounting bracket
(1) Mounting plate



Page 1 of 4 -- Page 2 of 4